WWB cannot be registered after hard drive cloning.

All WYSIWYG Web Builder support issues that are not covered in the forums below.
Forum rules
IMPORTANT NOTE!!

DO YOU HAVE A QUESTION OR PROBLEM AND WANT QUICK HELP?
THEN PLEASE SHARE A "DEMO" PROJECT.



PLEASE READ THE FORUM RULES BEFORE YOU POST:
http://www.wysiwygwebbuilder.com/forum/viewtopic.php?f=12&t=1901

MUST READ:
http://www.wysiwygwebbuilder.com/getting_started.html
WYSIWYG Web Builder FAQ
Post Reply
MUDJ
 
 
Posts: 79
Joined: Sun Jan 10, 2010 2:22 pm

WWB cannot be registered after hard drive cloning.

Post by MUDJ »

Hello.
I have a problem.
I had to clone my system hard drive (an M2 nvme) because it was starting to give me problems as it worked but sometimes it didn't and it wasn't recognized by the bios of the pc. I cloned it and booted up. Everything seemed to work fine. It opens the program as if it's registered, only it's not. On the "about" page it indicates that it is in demo version. How do I restore registration?
I tried to reinstall it but the page where to enter the registration data does not come out. I do not know how to do. Can you help me solve it?
Thank you for help me.
Regards.
User avatar
BaconFries
 
 
Posts: 5324
Joined: Thu Aug 16, 2007 7:32 pm

Re: WWB cannot be registered after hard drive cloning.

Post by BaconFries »

You can contact Pablo at the following email please include the original email address used to purchase and the serial of the version. Do not post any of this here thanks.
orders@pablosoftwaresolutions.com
MUDJ
 
 
Posts: 79
Joined: Sun Jan 10, 2010 2:22 pm

Re: WWB cannot be registered after hard drive cloning.

Post by MUDJ »

Ok! Thanks!!!
Post Reply